- Arming Lockout Harness and Key w / Lanyard Assembly
Arming Lockout Harness and Key w / Lanyard Assembly
Product #: 011-0067-01
Note: If you are attempting to redeem a coupon for a free Arm Lock Key (Included with Phoenix Edge series ESCs), please order part number 011-0067-00.
- Accessories : Other Accessories
- Availability: Currently Out of Stock
Before completing any of the following steps, make sure that the Edge ESC’s AUX LINE mode is set to “Arm Lock Key”. This setting can be found on the “OTHER” tab in the Castle Link software.
The socket may be installed through a panel or secured inside a fuselage. Do not overtighten rear nut against wiring; this can prevent proper operation.
Connect the black/red/white wire to the Aux Line (white wire) on an Edge ESC.Connect the black/red wire to any servo wire with a Y harness or to any empty channel on the Receiver.
Key in socket OR disconnected wire in socket harness = ARM LOCKED. A properly programmed and wired Edge will be incapable of arming when the key is in the socket. If the key is placed in the socket or the arm lock socket loses power, the ESC will go into a locked state - even if it is running. Key removed and power to socket = ARM UNLOCKED. ESC must receive low throttle signal to arm and run.
*The ARM LOCK KEY feature should be used as an extra safety measure NOT to replace general safety precautions.
Edge Arm Lock mode is intended as a secondary safety device. It is not intended to replace safe practices or careful handling of your RC power system, vehicle, and transmitter.Edge Arm Lock is only operational if you have successfully configured the Edge ESC using Castle Link software.Edge Arm Lock requires that the AUX LINE of the Edge ESC receives a voltage between 1.8V and 8.4V to arm. Failure of the power source (0 volts) will cause the ESC to enter ARM LOCKED mode.
Do not mount the Edge Lock Harness to a conductive material (e.g. metal, carbon fiber, etc.).
This product may contain chemicals known to the State of California to cause cancer and or birth defects or other reproductive harm.
Product designed in Olathe, Kansas USA.
Product made in China.