-B.jpg?fv=B619A6CF26C029FA0508FDC28E7DDCC4 "GHOST RC 1721-2400KV -1 / 5TH SCALE DRAG RACING")
-T.jpg?fv=76BAEC21EFAC62017CEAFE9A1026773E)
-T.jpg?fv=795027202321C917CA92362CDF786726)
-T.jpg?fv=4807FD9B89B9306B769FF1A65519B2DB)
GHOST RC 1721-2400KV -1 / 5TH SCALE DRAG RACING
Product #: 060-0125-00
ACE THE LAUNCH. OWN THE FINISH.
The new GHOST RC 1721-2400kv motor is based on Castle's proven 4-pole sensored design and has been redesigned for GHOST MODE. Engineers have made improvements in reliability and performance for the speed run and drag racing communities. The 1721-2400KV pairs perfectly with the GHOST RC COBRA 5 ACE, providing an incredibly powerful racing setup.
ENHANCEMENTS FROM PREVIOUS GENERATION:
- Larger rear bearing to provide more support at higher RPM
- Longer output shaft (30mm vs 22mm on the previous version)
- Winding wires extend directly from the back of the motor, decreasing resistance.
- 8mm shaft extends the full length of the rotor, increase strength and balancing
- Stainless-steel wrapped rotor and ultra balanced shaft to protect in high RPM applications
SUPPORT: Castle Creations does not provide technical support or service on Ghost RC products, nor does Castle offer trade-ins for this product as it is not a Castle product. Please contact Ghost RC for any questions regarding their products.
WARNING: Due to the abusive nature of drag and speed run setups, Castle nor Ghost RC is liable for incidental or consequential damages to other equipment such as ESCs and batteries when using this motor and is not responsible for failures resulting from abuse, improper installation, misapplication or alteration. Drag and speed run setups are inherently abusive and extremely hard on all electronic components. Every component in the configuration can be strained, weakened (or worse) without using extreme caution, observance of electric theory and advanced knowledge of all aspects of the RC hobby. High speed runs and drag racing are the most advanced, aggressive and volatile applications in the RC car hobby. Improper setup or use of this product can result in catastrophic failures of the motor, ESC and/or batteries. This motor is for advanced enthusiasts and should be used with caution.
- Availability: Not available
- Ghost RC Exclusive Item
| Technical Specs | |
|---|---|
| Input Voltage Range: | Max: 8s LiPo (33.6V) |
| Kv: | 2400 |
| Max. RPM: | 90,000 |
| Size: | Length: 102.3mm (4.03") (not including wires) Diameter: 47.7mm (1.88") |
| Weight (w/wires): | 751.3g (26.5oz) |
| Shaft Size: | Length: 30mm Diameter: 8mm |
| Mounting Hole Specifications: | M3 and M4 @ 25.4mm (1") |
| Connectors: | No bullet connectors included. Motor has bare stator wires (59mm length) DO NOT CUT OR SHORTEN FACTOR STATOR WIRES. Must solder flexible, silicone wires to stator wires motor. Do NOT attach male bullets directly to the factory stator wires and plug directly into the female bullets on the ESC. This will induce vibrations into the ESC's bullets and can cause them to detach. |
| Product Use Statements: |
This is an extremely powerful motor designed for advanced and experienced users only. Below are suggestions for increasing your likelihood of success but it is not guaranteed:
|
| Recommended ESC(s): | GHOST RC COBRA 5 ACE |
| Running Modes: | SmartSense™ (with Castle Sensor capable ESC), Sensored and an ultra-efficient Sensorless mode. |
| Tech Notes: | Please refer to this document for running and maintaining motors in wet environments. |
| Resources |
|---|
| Sensored Motor Quick Start |
This is a high-power product with the potential to be very dangerous. Please read the safety information before use. This product may contain chemicals known to the State of California to cause cancer and or birth defects or other reproductive harm.
Motor designed in Olathe, Kansas USA.
Motor manufactured in China.
-
< Previous product - End of search