Losi Mini-B - 1007 series only Vehicle modifications required Cut ~1" from left rear side guard. Bend angled part of chassis where motor sits, flat with rest of chassis. We used a pair of pliers, the bends quite easily. Installation picture. INSERT PICTURE URL HERE
LC Racing LC12B1 - 1007 or 1010 series No vehicle modifications required.
Does require front endbell to be rotated 120° to allow for solder tab clearance.
Use a high quality 1.5mm hex wrench (MIP highly recommended) as the screw heads are easy to strip. Remove all 3 button head screws that attach front endbell. Rotate front endbell 120° so solder tabs are orientated downward. Reattach button head screws; they will be very lose, so use thread lock/Loctite.
Traxxas 1/16 E-Revo - 1007 series only Vehicle modifications required.
The output shaft on the motor is too long. You can either cut a small slot in the motor plate (TRA7077R) to allow for shaft clearance or grind off ~4mm from the motor shaft (not recommended). If you have the brushed edition 1/16th E-Revo, you will need a different motor mount. The brushed edition has 25.4mm bolt spacing for the motor mount; this will not fit the 1007 motors.
You will need the following parts, used on the VXL (brushless) edition, to mount a 1007 motor. TRA7060 - Aluminum Finned Motor Mount TRA7077R - Gear Cover w/Motor Mount Hinge Post TRA7090 - Motor Plate (Blue)
