Downloads > FRH-Barracuda | FRH-Berg | SRH-Castle Link | FRH-Hydra | FRH-Mamba | FRH-Mamba Max | FRH-Phoenix | FRH-Sidewinder | FRH-Thunderbird


Firmware Revision History - Mamba Max and Mamba Max Pro

Release Notes
Version Number Type Release Date Release Notes
1.25 Final 02/12/10
  • Fixed stick programming of brushed modes
  • Fixed max drag brake not working
  • Fixed punch control stick programming comming up invalid value
  • Fixed power limited takeoffs with very high roll-out vehicles in sensored mode
1.24 Final 12/29/09

Mamba Max Pro One Cell:

  • Initial release of software
1.24 Beta 10/25/09

Mamba Max Pro:

  • Bug fix: Sensorless start was rough at low speeds
1.23 Beta 10/08/09

Mamba Max:

  • Added ability to program Mamba Max via the receiver cable with a Castle-Link device (instead of being required to plug the unit into a USB port)

Mamba Max Pro:

  • Increased the possible timing advance range for C.H.E.A.T. mode
  • Increased power output while in C.H.E.A.T. mode
1.21 Beta 05/07/09
  • Added ability to change the 'Auto-Lipo' cutoff voltages
  • Added ability to turn off the power-on reminder beep
  • Improved low speed operation, detects and escapes cogging better
  • Added ability to reverse motor direction by Castle Link software
  • Added Mamba Max Pro software
  • Bug fix: Rare instance where throttle was applied and controller would stay in idle
  • Bug fix: Audible power pulse in transition from throttle to drag brake
1.17 Final 01/22/08
  • Force a full re-arm after manual programming
  • Minor bug: setting drag brake via stick programming showed a custom value of 1% below the desired value on Castle Link
  • Minor bug: Loading and saving programming information to a file did not properly update calibration data
  • Added tone that repeats every ~20 seconds to let user know a battery is plugged in
1.16 Beta 01/21/08
  • New start algorithm vastly improves cogging, rolling backwards starts, and general throttle feel.
  • Added Throttle Dead Band adjustment
  • Added Arming Time adjustment. This is used so that spread spectrum receivers have time to synch before the unit becomes armed.
  • Added calibration information to Castle Link display
1.09 Final 02/13/07
  • Fixed an issue that could cause an error counting the number of cells in Auto-Lipo mode
1.07 Beta 07/07/06
  • Initial release